Specials

EPO100® Epoxy Resin Glaze 30L

Product Code: EPO100G-30
Availability: In Stock
$650.00
Qty:     - OR -   Add to Wish List

Epoxy Resin Glaze EPO100G:

This High Performance Industrial Epoxy is a 100% solids, two-pack cycloaliphatic amine cured epoxy resin matrix system. EPO100G Glaze Epoxy resin is designed as a long term flooring solutions. Glaze is formulated to eliminate fish eye and separation issues when applying as a roll coat system.

-         No VOC's (Volatile Organic Compounds)

-         Low Viscosity

·         Non-blushing

·         Non-water spotting

·         High gloss

·         Self-levelling

·         Excellent adhesion

·         Chemical resistant

·         High build application

·         Abrasion Resistant

·         Bond strength stronger than concrete

Designed for use in a wide range of commercial and industrial environments where a long term flooring solution is required. The exceptional resistance to a wide variety of chemical spillage and fumes makes this product ideal for use in high traffic environments.

Please read our Information sheet to understand the differences between Epoxies and how to distinguish between a high quality product such as EPO100 and a lesser quality product. Epoxy General 2013

Please read the Data Sheet and MSDS prior to using our products.

Epoxy can be applied using:


                                                                                               


Surface Preparation.

Surfaces must be clean, dry and free from all traces of loose material, old coatings, curing compounds, release agents, laitance, oil and greases etc. 

Application.

We recommend thinning the first coat with up to 30% Epoxy Thinners to ensure high penetration and adhesion, subsequent coats can be thinned but sufficient curing time is needed to release thinner out of coating 12hrs at 20deg. Pot life for a 10 lt batch is approximately 40 minutes at 25 deg.C, so mix only the amount of epoxy that can be easily applied within that time limit. Apply using a brush, or roller. Use a lint free epoxy roller to apply the product. For a lightly textured finish Dimple can be added with at least 25% Thinners or .65 Glass can be broadcast over surface for non slip.

Mixing Instructions.

Mix Part ‘A’ thoroughly using a power drill with paint mixing attachment.

Mix 2 parts ‘A’ with 1 part ‘B”.

Thinners can be added prior to mixing.

Mix thoroughly using a power drill with paint mixing attachment for 2 minutes, ensuring sides are well mixed.

Always wear a mask and avoid breathing vapors of resin or dust residue.

Technical Description
Solids Content 100% ww
Pot Life 30 - 45 minutes, depending on temperature.
Tack Free Time 12 Hours
Re-Coat 12 - 48 Hours
Initial Hardening 24 Hours @ 25 Degrees
Full Chemical Cure 7 Days @ 25 Degrees
Film Thickness 300 Microns approx per coat / Unthinned
Coverage Rate
2-3m2 per litre for porous & high profile substrates. 
5-6m2 per litre for low profile & dense substrates. 
Serviceable Life 5 - 10 Years
Recommended Uses
Garage, Factories & Workshops, Warehouses, Loading Bays, Washrooms, Food Prep Areas/Processing Plants etc.

*Coverage rates for coatings are based on smooth dense surfaces. The surface texture and porosity of the concrete can vary considerably and allowance should be made for this.

Kit
Kit 1 x 20L Epoxy Resin Glaze PART A EPO100G 1 x 10L Epoxy Hardener PART B EPO100G

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: